Table of Contents
A Washer Warns You Before It Floods
It starts as a shirt that comes out wetter than usual, a rumble that only appears on the spin, or a damp patch under the front lip that dries by evening. Left alone, those turn into a failed bearing or a laundry room under water. Washer repair booked at the noise stage is a suspension part; booked after the flood it is a bearing and a floor.
A+ Appliance Repair and Maintenance covers front-load, top-load, stacked and compact machines across Chicago and the western suburbs — including closet installations and second-floor laundry rooms where a leak reaches the ceiling below.
Need service? Call (855) 555-0143 or book online.
Where the Water Is Coming From
Water on the floor is almost never the tub. On a front-loader it is the door boot, the drain pump housing or a split hose; on a top-loader it is the inlet valve or the pump. We pressure-test before quoting so you are not paying for a guess.
| What you notice | Where we look first |
|---|---|
| Puddle at the front after a wash | Door boot, torn at the six-o’clock position |
| Water under the machine, not in front | Drain pump housing or the sump hose |
| Fills forever, or will not stop | Inlet valve or pressure switch — hard water is unkind to both |
| Drum will not spin or drain | Coin trap, drain pump, or a failed shifter on a top-loader |
| Banging on the spin cycle | Suspension rods or shock absorbers |
| Clothes soaking wet at the end | Not reaching spin speed: drain restriction, lid switch or speed sensor |
| Walks across the floor | Levelling and shipping bolts before anything mechanical |
The Repairs We Do Most
Top-load machines
On the Whirlpool and Maytag platform, a washer that fills but never agitates is the shifter assembly nine times out of ten. It is a known wear item, it travels on the van, and it is normally a single-visit repair. The lid lock switch is second on the list and is frequently mistaken for a control board failure.
Front-load machines
Drain pumps and door boots dominate. Bearings are the one repair that can cost more than the machine is worth — on a newer or premium machine it is worth doing, on an eight-year-old budget unit it usually is not, and we will tell you which side of that line you are on before ordering anything.
Stacked and closet installations
Common in the condos and townhomes around Yorktown and through Bolingbrook. These are serviced in place; we do not need the unit pulled into the hallway first. Mention building access and elevator rules when you book so the visit is scheduled inside them.
Washers We Repair
- Front-load washers, including stacked and under-counter installations
- Top-load machines with and without a centre agitator
- Washer-dryer combination units and compact 24-inch machines
- European platforms with water softeners and integrated dosing
- Light commercial machines in small laundries and multi-unit buildings
Washer Brands We Service
What Washer Repair Costs
Diagnostics are $79 and credited to the repair. Most washer jobs finish between $199 and $450 depending on the part: shifters, lid locks, drain pumps and door boots at the lower end, control boards and bearing work at the top. Because the common parts travel on the van, roughly four out of five laundry calls are completed the day we arrive.
Why Choose A+ for Washer Repair
- Leaks get pressure-tested, not guessed at — you pay for the part that is actually failing.
- Common parts on board, so most repairs finish on the first visit.
- Straight answer on bearings, including when the machine is not worth the job.
- Written warranty on the part and the labour.
Frequently Asked Questions
My washer fills but the drum never moves. Is that the motor?
Almost never. On top-loaders it is the shifter assembly that moves the drive between agitate and spin — a known wear item, stocked on the van, usually fixed the same visit.
Why does my front-loader smell even after cleaning it?
Front-loaders trap water in the door boot and the detergent drawer. A proper service clean of the boot, drawer and drain filter solves most of it. If the smell survives that, the pump housing is holding standing water.
Is a drum bearing worth replacing?
On a premium or recent machine, yes. On an older budget unit the labour alone approaches the price of a replacement, and we will say so rather than sell the job.
My machine walks across the floor. Is it broken?
Usually not. Check that all four feet are level and that the shipping bolts were removed at installation — a surprising number never were. If both are right, the suspension is the next thing to look at.
Can you service a washer in a second-floor laundry room?
Yes, and a leak up there gets priority scheduling. Water on a first floor is a different urgency from water in a basement.
